X-Press It TripleTac 250ml

• Water based

• Acid free & non-toxic

• Dries clear

• Fast drying

• Matt finish

• Excelent holdout

Applications: Use on paper, canvas, cardboard, wood, metal, leather & some plastics.

Adhesive: Apply a thin even coat to surface & position substrate immediately. For a stronger bond, apply to both surfaces. Ensure all air bubbles are removed by applying firm even pressure across the surface. Weight can be applied for a few hours to enhance the adhesion. 

Sealer: Using a brush, apply a thin even coat to the entire area. Allow to dry for approximately 20 minutes and repeat 2-3 times as required. If a fast top coat is required, apply a more generous layer to the surface whilst keeping the surface smooth.

Transfer Medium: Apply a generous coat of TripleTac to the surface that you are transferring the image onto. Images printed from a laser printer or patterned paper will give the best results. Place the image onto the coated surface facedown & allow to dry. (24 hours is recommended) Using a small amount of water, gently rub the back of the paper with a wet finger or cloth, until the paper starts to pill. Continue wetting & rubbing, until the image is revealed. To avoid patchy results, take care not to rub too much in one area. Apply a second coat of TripleTac, to seal the image.